Refer to the exhibit. Which route was configured as a static route to a specific network using the next-hop address?
- S 0.0.0.0/0 [1/0] via 10.16.2.2
- S 10.17.2.0/24 is directly connected, Serial 0/0/0
- C 10.16.2.0/24 is directly connected, Serial0/0/0
- S 10.17.2.0/24 [1/0] via 10.16.2.2
The C in a routing table indicates an interface that is up and has an IP address assigned. The S in a routing table signifies that a route was installed using the ip route command. Two of the routing table entries shown are static routes to a specific destination (the 10.17.2.0 network). The entry that has the S denoting a static route and [1/0] was configured using the next-hop address. The other entry (S 10.17.2.0/24 is directly connected, Serial 0/0/0) is a static route configured using the exit interface. The entry with the 0.0.0.0 route is a default static route which is used to send packets to any destination network that is not specifically listed in the routing table.