In which situation would a technician use the show interfaces switch command?
- to determine if remote access is enabled
- when an end device can reach local devices, but not remote devices
- to determine the MAC address of a directly attached network device on a particular interface
- when packets are being dropped from a particular directly attached host
The show interfaces command is useful to detect media errors, to see if packets are being sent and received, and to determine if any runts, giants, CRCs, interface resets, or other errors have occurred. Problems with reachability to a remote network would likely be caused by a misconfigured default gateway or other routing issue, not a switch issue. The show mac address-table command shows the MAC address of a directly attached device.