A company uses the method SLAAC to configure IPv6 addresses for the workstations of the employees. A network administrator configured the IPv6 address on the LAN interface of the router. The interface status is UP. However, the workstations on the LAN segment did not obtain the correct prefix and prefix length. What else should be configured on the router that is attached to the LAN segment for the workstations to obtain the information?
- R1(config-if)# ipv6 enable
- R1(config)# ipv6 unicast-routing
- R1(config-if)# ipv6 nd other-config-flag
- R1(config)# ipv6 dhcp pool < name of the pool >
Answers Explanation & Hints:
A PC that is configured to use the SLAAC method obtains the IPv6 prefix and prefix length from a router. When the PC boots, it sends an RS message to inform the routers that it needs the information. A router sends an RA message that includes the required information. For a router to be able to send RA messages, it must be enabled as an IPv6 router by the unicast ipv6-routing command in global configuration mode. The other options are not used to enable IPv6 routing on a router.