3.1.1.3 Lab – Install the Power Supply
[TABS_R id=5943]
Lab – Install the Power Supply (Answer Version)
Introduction
In this lab, you will install a power supply in a computer case.
Recommended Equipment
- Power supply with a compatible form factor to the computer case
- Computer case
- Tool kit
- Power supply screws
Step 1: Open the Computer Case.
- Remove the screws from the side panels.
- Remove the side panels from the computer case.
Step 2: Install the Power Supply.
- Align the screw holes in the power supply with the screw holes in the case.
- Secure the power supply to the case with the power supply screws.
- If the power supply has a voltage selection switch, set this switch to match the voltage in your area.
- What is the voltage in your area?
- ____________________________________________________________________________________
- Answers may vary. Either 110/115v or 220/230v.
- How many screws secure the power supply in the case?
- ____________________________________________________________________________________
- Answers may vary. Usually 4.
- What is the total wattage of the power supply?
- ____________________________________________________________________________________
- Answers may vary.
- This lab is complete. Please ask the Answer to verify your work.
[TABS_R id=5943]